Call now to get tree assist just as tree removal, tree remove, bush fell, shrub trim, stump hauling and plenty of other across USA:


Click to call

Call +1 (855) 280-15-30






Do not apply lubrication to the bushing case because it will allow the bushing.

This is a video of replacing upper and lower control arm bushings with energy suspension polyurethane bushings. Here we replace the control arm bushings with.

Nov 02, 3. Remove the control arm bolts from the rear axle. 4. Use the utility stand in order to lower the rear axle enough to gain access to the control arm bushing. 5. Mark the orientation of the control arm bushing in the lower control arm. 6. Use the J and the JE in order to remove the control arm bushing. Installation Procedure 1.

May 11, Rear Upper Control Arm Bushings. This topic has 8 replies, 3 voices, and was last updated 1 year, 3 months ago by 62cutlassconvert. Does anyone have a source for rear upper control arm bushings. The service manual says the entire control arm is replaced as a unit but I thought there was an old thread on here regarding bushing replacements.

Larger Image. Rear Upper Control Arm Bushing Tool makes it much easier to change the rear control arm bushings at the differential. Watch the video--Click on the video tab above to see this tool in treecutting.buzz bushings are a press fit in the differential housing, and are difficult to access when not removing the rear axle assembly from the car.

how to remove the rear upper control arm on a w W chassis - Cars & Trucks question. Feb 14, Well, yesterday I was working on my new suspension setup and I got stuck on 2 bolts that holds the upper control arm on the treecutting.buzz is a total of 4 bolts what's the best way to put these bolts back in?

I've tried using a jack underneath, but it still won't go in at the right angle I played with it for hours, and it still wouldn't go in:confused::mad: any help would be appreciated!

Viewing 9 posts - 1 through 9 of 9 total.

Apr 23, Upper control arm bushing install Discussion in 'Suspension, Steering, Brake & Wheel Topics Here is a picture of me using a ball joint tool to remove a UCA bushing, but to install it I used the same tool just in the opposite direction pictured: It should work for the rear upper with a.

Jul 24, Just got back the sub frame, upper and lower control arms from powder coating. I went to install the new upper control arm bushings (all the same size right? Not on my car). While"dry" fitting the new bushings, in prep to press them in, I found the rear, right bore hole is about 3/8" larger, than the the other 3 upper control arm bushing boring's.